Wire harness - for SIMIN KR50 with safety circuit

Wire harness - suitable for series with a DC signal horn - signal horn is powered from a 3V battery (2 monocells - 1.5 volts) - for this a battery tank is installed on the vehicle frame - the wiring harness is designed in terms of circuitry in such a way that the Headlight lamp (high beam or dipped beam thread burned out) The rear light automatically goes out without the rear light lamp burning out - Scope of delivery: - Cable to the rear light - Cable to the motor - Cable to the dipped beam switch - Cable to the signal horn - Cable to the battery container - Mass cable in headlight - cable connector and releasable cable tie - Colored electrical circuit diagram - New rubber grommets in set (2x for headlight housing, 2x for Bowden cables Fitting sheet, 1x special sleeve for Low beam switch, 1x for Bowden cable in the front mudguard) Quality features: - Wiring harness is handcrafted and meets high demands on quality and dimensional accuracy - Connections are equipped with slim ferrules - connections to the low beam switch are tinned - Cable lugs are pressed and soldered - the original colors and cable cross-sections were used for the cables - cable sheathing is made of high-quality PVC hose and is optimally adapted to the number of wires