Set: Circuit Optimization Special

Set: Circuit optimization - The set includes: Bolt special for shift roller screwed, swivel lever optimized and needle bearing for shift roller bolt-special for shift roller screwed - easy assembly of the shift roller, no pressing in required - easy adjustment of the axial play of the shift roller - Bearing disc is not required, fully rotated on the bolt - improves the shifting behavior - Made in Germany - hardened - perfect for racing use - locking ring 12x1 DIN 471 not applicable - the shifting roller is secured via a screw connection with a rosette washer - is in the left Engine half plugged in and screwed - Motor must be opened for assembly Note: Insert bolts with screw lock into the housing with high strength! Swivel lever optimized - swing lever optimized for shifting - reduced play between shift roller and swivel lever - better adjustability and switching accuracy - pins on the swivel lever is turned off and a drill bush has been pressed on - additional screw lock was used for safety - the pin is accurate through the drill bushing 8.00mm external dimensions, hardened and ground Note: Swivel lever is designed for 5-speed shift rollers or replica 3 or 4-speed shift rollers. When used on 3 or 4 gear DDR shift rollers, the groove must be checked before purchase. Some of the milled grooves are less than 8mm and thus the swivel lever cannot be mounted. A replica shift roller can be used for this purpose, which has a groove width of approx. 8.1mm. Needle bearing for roller - reduces shift roller radial clearance - Improved shifting, direct and lighter - is pressed into shift roller - ideal for 5-speed gearbox - fits for shift roller bolts and shifting roller bolts - last picture shows installation location on Pushing Roller Bolts - Shift Roller Bolts Not Included Note: Needle bearing is adapted for 5-speed MZA shift rollers. When used in other switch rollers, such as B.: 4-speed DDR, adjustments may be required. Check switch roller bolts! DDR switch roller bolts vary in dimensions and can therefore have a diameter of more than 15.0 mm at the bearing point. The switch roller bolt must not exceed 15.0 mm, if necessary replica use of the shifting roller bolts or bolt-roller bolts.